Bnc 645 User Manual download pdf (Page 131)

131

BUTSt:GATE:POLarity?

“NORM” or “INV” will be returned.

-- C --

CALibration?

Perform a calibration using the specified calibration value (CALibration:VALue

command). You need to enter a correct security code (see CALibration:

SECure:STATe) before you can calibrate the waveform generator.

CALibration:COUNt?

Query the number of times the waveform generator has been calibrated. Note

that your instrument was calibrated before it left the factory. Check the

calibration count when you receive your waveform generator to determine it

initial value.

CALibration:SECure:CODE <new code>

Set a new security code. You have to first use the old security code to unsecure

the waveform generator and then set a new security code. A security code may

contain up to 12 characters and the first character must be a letter (A-Z). The

rest of the characters can be any combination of numbers (0-9), letters and

underscore character (“_”).

CALibration:SECure:STATe {OFF|ON},<code>

Unsecure or secure the waveform generator for calibration.

CALibration:SECure:STATe?

Query the secured state of the waveform generator. Return “0” (OFF) or “1”

(ON).

CALibration:SETup <0︱1︱2︱3︱…︱94>

Configure the waveform generator’s internal state for each of the calibration

step to be performed.

CALibration:SETup?

Query the calibration setup number. Return a value from “0” to “94”.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 189 190

No comments

Bnc 645 User Manual Page 131