Bnc 645 User Manual download pdf (Page 164)

164

generator waits for all pending operations to complete before executing

any additional commands. For example, the following command string

guarantees that the first trigger is accepted and the operation is executed

before the second trigger is recognized.

TRIG:SOUR BUS;*TRG;*WAI;*TRG;*WAI

z You can use the *OPC? (operation complete query) command or the *OPC

(operation complete) command to signal when the burst is complete. The

*OPC? Command returns “1” to the output buffer when the burst is

complete. The *OPC command sets the “Operation Complete” bit (bit 0) in

the Standard Event register when the burst is complete.

TRIGger:SOURce?

Query the trigger source. “IMM” or “BUS” or “EXT” string indicating the trigger

source will be returned.

TRIGger:SLOPe {POSitive︱NEGative}

Specify whether the rising (positive) or falling (negative) edge of the trigger

signal is to be used for an externally-triggered sweep. The default is POS.

TRIGger:SLOPe?

Query the trigger slope. “POS” or “NEG” string indicating the trigger slope will be

returned.

-- U --

UNIT:ANGLe {DEGree︱RADian}

Specified the unit of the starting phase for the burst with the BURS:PHAS

command. The default is DEG. Radians are not available from the front panel, so

if switching to the front panel operation after using radians on the remote

interface operation, the waveform generator automatically converts the unit

back to degrees for you.

UNIT:ANGLe?

“DEG” or “RAD” indicating the unit of the starting phase for the burst will be

returned.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 189 190

No comments

Bnc 645 User Manual Page 164