Bnc 645 User Manual download pdf (Page 67)

Set the end address of the pattern.

Set the trigger source of the pattern, such as from EXT or BUS. (Please

note that there is no IMM internal trigger.

Set the Trigger slope of the pattern out to be a positive (rising) edge or

a negative (falling) edge.

Set the pattern repeat again, yes (ON) or no (OFF).

Select which clock edge to latching data of the pattern, positive (rising)

edge or negative (falling) edge.

PATTERN OUT Commands:

(Add Pattern Out Commands)

FUNCtion:PATTern {data name}

Select file name of the pattern, such as EXP_RISE, EXP_FALL,

NEG_RAMP, SINC, CARDIAC.

FUNCtion:PATTern?

Inquire and gain the file name of the pattern.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 189 190

No comments

Bnc 645 User Manual Page 67