Bnc 645 User Manual download pdf (Page 111)

111

All non-volatile memory locations are occupied. There is no room to

store a new waveform.

781 Not enough memory to store new arb waveform; bad sectors

Due to storage hardware failure, new waveforms cannot be saved.

782 Cannot overwrite a built-in waveform

The five built-in waveform names (“EXP_RISE”, “EXP_FALL”,

“NEG_RAMP”, “SINC”, and “CARDIAC”) are reserved and cannot be

used with DATA:COPY command.

784 Name of source arb waveform for copy must be VOLATILE

When using the DATA:COPY command, the data source must be the

VOLATILE one.

785 Specified arb waveform does not exist

Before using DATA:COPY command to copy from the volatile memory,

be sure to download the waveform to it using the DATA VOLATILE or

DATA:DAC VOLATILE command.

786 Not able to delete a built-in arb waveform

Deleting the built-in waveform is not allowed.

787 Not able to delete the currently selected active arb

waveform

Deleting the waveform that is currently outputting is not allowed.

788 Cannot copy to VOLATILE arb waveform

You can only use DATA:COPY command to copy from VOLATILE, not to

VOLATILE.

800 Block length must be even

The binary data are represented as 16-bit integers. They are sent in

groups of two bytes (DATA:DAC VOLATILE command).

810 State has not been stored

The storage location specified in the *RCL command was never used in

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 189 190

No comments

Bnc 645 User Manual Page 111