Bnc 645 User Manual download pdf (Page 66)

a. To specify the trigger source, press the softkey under Src

and then select among Ext (external) and Man (manual).

If manual trigger is selected, you may configure the trigger

out signal by pressing the softkey under Trig Out and then

select among OFF, rising-edge trigger and falling-edge

trigger.

If external source is selected, you may press the softkey

under Slope to toggle between rising edge trigger and

falling edge trigger.

Press the softkey under DONE to finish the trigger setting.

Pattern Out

This is a parallel interface including an edge-selectable clock and 16-bit

data. You can use this interface to send any data through this interface at

the speed 1uHz to 50MHz.

Press the soft key [PATT Mode] to select Pattern Mode

Set the frequency of the pattern clock, 1uHz ~ 50MHz.

This setting is familiar with Figure 3-3 frequency setting.

Select file name of the pattern, such as EXP_RISE, EXP_FALL,

NEG_RAMP, SINC, CARDIAC. This setting is same as arbitrary waveform

selection.

Set the start address (min. 1) of the pattern.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 189 190

No comments

Bnc 645 User Manual Page 66